Table of Contents
Advertisement
Crestron C2N-SDC
NOTE: If communication cannot be established, refer to the
"Troubleshooting Communications" section in the 2-Series Control
Systems Reference Guide (latest version of Doc. 6256) for details. If an
earlier control system is used, refer to the latest version of that control
system's Operation Guide.
There are two different methods—Method A or Method B—for setting
the C2N-SDC Net IDs:
Method A (Cresnet address-settable ID), described below, applies to
C2N-SDCs in a Cresnet system with a CNX control system or with a
2-Series control system upgrade file (CUZ) version prior to 3.008, but
can be used with later versions of firmware and requires that a single unit
be the only network device connected to the control system.
Method B (Touch Settable IDs), which begins on the next page, applies
to C2N-SDCs in a Cresnet system with 2-Series control system upgrade
file (CUZ) version 3.029 or later. These upgrades enable Touch Settable
ID (TSID) functionality, which makes it possible for the control system
to recognize a network device via its serial number, which is stored in the
device's memory. This method does not require that any devices be
disconnected from the network; Net IDs may be set with the entire
Cresnet system intact. This method requires the use of the Crestron
Viewport version 3.35 or later.
Use the appropriate method to set the C2N-SDC Net ID.
Method A (Cresnet address-settable ID)
Operations & Installation Guide - DOC. 6316
1.
Ensure that the C2N-SDC is the only device connected to the
control system.
2.
Open the Crestron Viewport.
3.
From the Viewport menu, select Functions | Set Network ID.
The software checks the baud rate and then opens the "Set
Network ID" window.
4.
In the "Set Network ID" window, select the C2N-SDC from
the Current Network Devices text window.
5.
Select the new Net ID for the C2N-SDC from the Choose the
new network ID for the selected device (Hex): text box.
6.
Click Set ID to initiate the change. This will display the "ID
command has been sent" window.
Shade & Drape Motor Controller
Shade & Drape Motor Controller: C2N-SDC •
9
Advertisement
Table of Contents
