Industry Compliance - Crestron C2N-FT-TPS4 Operations & Installation Manual

Crestron C2N-FT-TPS4/TPS4-U
125V – 50/60Hz 10A
NET
24 Y Z G 24 Y Z G
Green Yellow
LED
8 1
Operations & Installation Guide – DOC. 6398
Controls and Ports (Top)
Buttons
The TPS-4 touchpanel has 10 hard buttons; five on each side of the display. The
buttons are backlit with white LEDs; brightness is program adjustable. The
buttons can be programmed to automate frequently used functions.
AC Outlet (C2N-FT-TPS4 Only)
The 3-prong grounded AC outlet is rated 125 VAC @ 10 Amps, 50 – 60 Hz.
Ports (Underside)
NET
These two 4-pin terminal block connectors are for connection to the Cresnet
network. One connector is used to connect to the Cresnet network while the
second connector can be used to connect another Cresnet device. Cresnet
power to the TPS4 is supplied through either of these connectors. For more
information, refer to "Network Wiring" on page 8.
LAN
An 8-wire RJ-45 connector with two LED indicators (green LED indicates link
LED
status, yellow LED indicates Ethernet activity). This connector provides an
Ethernet 10baseT /100baseTX, full duplex, TCP/IP, UDP/IP, CIP, DHCP, IEEE
802.3U compliant network connection for the TPS4 touchpanel.
LAN Connector Pinout
PIN
1
2
3
4
AC Power (C2N-FT-TPS4 Only)
Connect the six-foot (183 cm) grounded AC line cord to supply AC power to the
outlet on the topside of the TPS4.

Industry Compliance

As of the date of manufacture, the TPS4 has been tested and found to comply with
specifications for CE marking and standards per EMC and Radiocommunications
Compliance Labelling.
NOTE: This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
FlipTop Touchpanel Control Center
SIGNALS
TX +
TX -
RC+
N/C
FlipTop Touchpanel Control center: C2N-FT-TPS4/TPS4-U • 7
PIN SIGNALS
5 N/C
6 RC -
7 N/C
8 N/C