Industry Compliance - Crestron CWD6671 Operation Manual

Two-Way RF Transceiver Module
4 • Two-Way RF Transceiver Module: CWD6671
Antenna
This SMA reverse polarity female antenna port is located at edge of the circuit board
for attaching the included dipole antenna.
APPROVED ANTENNAS:
The CWD6671 antenna interface has a unique coupling designed to ensure that no
antenna other than the one supplied shall be used with the device. Replacement
antennas may be purchased from Crestron according to the following description:
Part Number: 2001016
Description: ANTENNA, 2400.00MHZ, DIPOLE, SMA, REVERSE POLARITY,
FEMALE

Industry Compliance

Labeling Requirements
If the FCC ID on the CWD6671 is not visible when the module is installed inside
another device, then the outside of the device into which the module is installed must
also display a label referring to the enclosed module. This exterior label can use
wording such as the following: "Contains Transmitter Module FCC ID:
EROCWD6671" or "Contains FCC ID: EROCWD6671." Any similar wording that
expresses the same meaning may be used.
Compliance Statement (Part 15.19 )
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference
that may cause undesired operation.
Warning (Part 15.21 )
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
RF Exposure (OET Bulletin 65 )
To comply with FCC RF exposure requirements for mobile transmitting devices, this
transmitter should only be used or installed at locations where there is at least 20cm
separation distance between the antenna and all persons.
Industry Canada Statement
The term "IC" before the certification/registration number only signifies that the
Industry Canada technical specifications were met.
IC: 5683C-CWD6671
Section 7.1.5 of RSS-GEN
Operation is subject to the following two conditions:
1) this device may not cause interference, and
2) this device must accept any interference, including interference that may cause
undesired operation of the device.
Crestron CWD6671
Operations Guide - DOC. 6834