Crestron C2N-FT-TPS4 Operations & Installation Manual page 14

FlipTop Touchpanel Control Center
10 • FlipTop Touchpanel Control Center: C2N-FT-TPS4/TPS4-U
Duplicate Net ID Warning Message
This method does not change the Net ID as assigned in SIMPL windows. Refer to
page 20 for the SIMPL Windows ID change procedure.
NOTE: You may also use SystemBuilder to perform Network ID setup.
1. Ensure that all network devices are connected to the control system.
2. Open Crestron Toolbox and establish communications (refer to page 22).
3. Select the Network Device Tree
Device Tree. (Refer to the following figure.)
Network Device Tree
4. Click on the '+' next to the name of the device to display its current Net ID
setting, and then right-click on the Net ID you wish to change. When the
sub-menu appears, select Change Network ID from the sub-menu.
Network Device Tree – Sub-Menu
5. The current Net ID is highlighted. Enter a new Net ID and press Enter.
Enter New Net ID
Crestron C2N-FT-TPS4/TPS4-U
icon, or select Tools | Network
Operations & Installation Guide - DOC. 6398