Crestron C2N-FT-TPS4 Operations & Installation Manual page 17

Crestron C2N-FT-TPS4/TPS4-U
Operations & Installation Guide – DOC. 6398
Cutout Dimensions
TPS4 (4007478)
7.25 in
(18.42 cm)
6.13 in
(15.56 cm)
NOTE: Before inserting the TPS4 in the mounting hole, ensure that all required
cables have been installed.
Mounting Parts Supplied with the TPS4
PART DESCRIPTION
Screw #6-32, Pan Head, Phillips
Screw #10, Pan Head, Phillips
Mounting Bracket
1. Install the eight supplied #6-32 screws, but do not tighten (four on the front
side and four on the rear side). These will be used to secure the front and
rear mounting brackets.
2. Position the TPS4 in the mounting hole. (Refer to the following graphic.)
Mounting Bracket Screw Locations
3. Install the four #10 screws in the mounting brackets (two screws per
bracket). Refer to the following diagram.
4. Slide the mounting brackets over the #6-32 screws and tighten the
#6-32 screws.
FlipTop Touchpanel Control center: C2N-FT-TPS4/TPS4-U • 13
FlipTop Touchpanel Control Center
Max Radius
(0.125 in)
(0.32 cm)
QUANTITY
8
4
2