The module receives RF signals from one or more Crestron devices and can transmit these signals over the air or over a cable run for further processing (depending on the application).
Two-Way RF Transceiver Module Crestron CWD6609 Specifications The table below is a summary of specifications for the CWD6609. Specifications of the CWD6609 SPECIFICATION DETAILS Power Requirements 0.58 Watts (5.0VDC @ 0.115A) Operating Frequency 2400 MHz to 2483.5 MHz (802.15.4 compliant) Operating Ranges¹...
Page 7
NOTE: Pin 1 provides power to the circuit card. Power/I-O Pinout Signals Pin # Signal Pin # Signal REMOTE_B/CONFIG TRIAC/RELAY ZERO_X 3.3v REMOTE_A/RELAY Two-Way RF Transceiver Module: CWD6609 • 3 Operations Guide - DOC. 6838A...
Industry Compliance Labeling Requirements If the FCC ID on the CWD6609 is not visible when the module is installed inside another device, then the outside of the device into which the module is installed must also display a label referring to the enclosed module. This exterior label can use wording such as the following: “Contains Transmitter Module FCC ID:...
Page 9
FCC authorization is no longer considered valid and the FCC ID cannot be used on the final product. In these circumstances, the OEM integrator will be responsible for reevaluating the end product (including the transmitter) and obtaining a separate FCC authorization. Two-Way RF Transceiver Module: CWD6609 • 5 Operations Guide - DOC. 6838A...
Hookup Connections for CWD6609 ANTENNA: HOST PCB TRANSMITS AND RECEIVES RF SIGNALS CONTROL (LOCATED ON OTHER SIDE) For more information on these connectors, refer to “Ports” on page 3. 6 • Two-Way RF Transceiver Module: CWD6609 Operations Guide - DOC. 6838A...
20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter.” Two-Way RF Transceiver Module: CWD6609 • 7 Operations Guide - DOC. 6838A...