Table of Contents
Advertisement
™
Cameo
Keypads
14 • Cameo™ Keypads: C2N/C2NI-CB Series
3. Hold the bezel and rear housing together and install and tighten
the two supplied Phillips pan head, 4-40 x 3/16" cover screws
(black) into the rear housing and switch assembly, as shown in
the following illustration.
4. Press each button to be certain that you feel the press and
release to ensure that the button caps move freely.
Bezel
LED
Holes
LEDs
5. Attach the spring clamp to the rear of the keypad, as shown in
the following figure, by loosening the screws sufficiently to
place the clamp over the screws and slide it down into position,
and then retighten the screws.
Crestron C2N/C2NI-CB Series
Cover
Button Caps
Screw
and Spacers
Plastic Button
Support
Rear Housing
and Switch
Assembly
Loosen
Screws
Spring
Clamp
Operations & Installation Guide - DOC. 6346A
Advertisement
Table of Contents
