Table of Contents
Advertisement
Crestron C2N/C2NI-CB Series
Supplied Parts/Assemblies – UK-Style Mounting (continued)
QTY
2
6
3
2
2
1
1
2
Assemble the keypad as described in the following steps. Refer to the
accompanying illustration.
LED
Holes
LEDs
Operations & Installation Guide - DOC. 6346A
ITEM
Screws, Black, Phillips pan
head, 4-40 x 3/16"
Single row button cap
Double row button cap
Triple row button cap
Single row spacer
Double row spacer
Triple row spacer
Screws, Steel, Phillips, pan
head, 6-32 x 7/8"
1. Place the button caps and/or spacers in position according to the
program plan. Attach the plastic button support to the button
caps/spacers, and put the assembled parts in place on the Rear
Housing and Switch assembly. (Refer to the illustration for the
standard mounting installation procedures, step 1, on page 16.)
2. Carefully position the bezel assembly, LED edge first, down
and over the button caps/blanks and rotate slightly into position
on the rear housing and switch assembly.
3. Hold the bezel and rear housing together and install and tighten
the two supplied Phillips pan head, 4-40 x 3/16" cover screws
(black), as shown in the illustration.
Bezel
Button Caps
and Spacers
Used to attach the bezel assembly to the keypad rear
housing and switch assembly
Switch cover for a single row switch
Switch cover for two switches that function as one
Switch cover for three switches that function as one
Switch cover for single non-operational switch
Switch cover for two non-operational switches
Switch cover for three non-operational switches
Used only to attach assembled keypad to back box
Cover
Screw
Plastic Button
Suport
Rear Housing
and Switch
Assembly
Cameo™ Keypads: C2N/C2NI-CB Series • 19
™
Cameo
Keypads
DESCRIPTION
Advertisement
Table of Contents
