Table of Contents
Advertisement
Crestron C2N/C2NI-CB Series
Installation consists of connecting the unit to the Cresnet system, and
then mounting it directly to the mounting surface or to a back box,
depending on the keypad configuration.
The following items are required for all installations:
Flush Mounting Installation
The Cameo keypad for flush mounting installation is supplied partially
assembled along with several items as listed in the following table.
Supplied Parts/Assemblies – Flush Mounting
QTY
1
1
1
2
6
3
2
2
1
1
1
1
1
Assemble the keypad as described in the following steps. Refer to the
accompanying illustrations.
Operations & Installation Guide - DOC. 6346A
• Cresnet network cable (not supplied)
• No. 2 Phillips screwdriver (not supplied)
ITEM
Rear housing and switch assembly
Bezel
4-pin female mini network
connector
Screws, Black, Phillips pan head,
4-40 x 3/16"
Single row button cap
Double row button cap
Triple row button cap
Single row spacer
Double row spacer
Triple row spacer
Plastic button support
Spring clamp
Template
1. Place the button caps and/or spacers in position according to the
program plan. Attach the plastic button support to the button
caps/spacers, and put the assembled parts in place on the rear
housing and switch assembly. (Refer to the illustration for the
standard mounting installation procedures, step 1, on page 16.)
2. Carefully position the bezel assembly, LED edge first, down
and over the button caps/blanks and rotate slightly into position
on the rear housing and switch assembly.
Cameo
DESCRIPTION
Rear housing with switch circuitry attached
Bezel assembly
Used to connect Cresnet network cable to the keypad
Used to attach the bezel assembly to the keypad rear
housing and switch assembly
Switch cover for a single row switch
Switch cover for two switches that function as one
Switch cover for three switches that function as one
Switch cover for single non-operational switch
Switch cover for two non-operational switches
Switch cover for three non-operational switches
Used to hold the button caps/spacers together in
position
Used to secure the assembled keypad in the wall
Used to mark correct hole size in the wall
Cameo™ Keypads: C2N/C2NI-CB Series • 13
™
Keypads
Advertisement
Table of Contents
