Table of Contents
Advertisement
Crestron C2N/C2NI-CB Series
NOTE: Be very careful when cutting the hole. There are no adjustments
for alignment with the spring clamp.
Operations & Installation Guide - DOC. 6346A
6. Use the supplied template to prepare the hole in the wall. (Refer
to the Appendix on page 40 for an illustration of the template.)
After the Cresnet network wiring has been installed and
verified, use the following procedure to install the keypad in the
prepared hole.
7. Connect the Cresnet cable, using the supplied mating
connector, to the keypad's Cresnet port.
8. Make sure the keypad is oriented properly and insert the keypad
in the hole. The natural action of the spring clamp holds the
keypad in position.
9. Turn Cresnet system power ON.
10. If the keypad needs to be removed from the wall, there is a slot
on one edge of the bezel (refer to the figure). Use a small flat
blade screwdriver to pry the keypad away from the wall, being
careful to avoid damage to the wall surface, and use your
fingers to remove the keypad.
Cameo
Cameo™ Keypads: C2N/C2NI-CB Series • 15
™
Keypads
Slot
Advertisement
Table of Contents
