Table of Contents
Advertisement
™
Cameo
Keypads
Decorator Mounting Installation
The keypad for Decorator mounting installation is supplied partially
assembled along with several items as listed in the following table.
Supplied Parts/Assemblies – Decorator Mounting
QTY
1
1
1
2
6
3
2
2
1
1
1
2
Assemble the keypad as described in the following steps. Refer to the
accompanying illustrations.
16 • Cameo™ Keypads: C2N/C2NI-CB Series
ITEM
Rear housing and switch assembly
Bezel assembly
4-pin female mini network
connector
Screws, Black, Phillips pan head,
4-40 x 3/16"
Single row button cap
Double row button cap
Triple row button cap
Single row spacer
Double row spacer
Triple row spacer
Plastic button support
Screws, Steel, Phillips, pan head,
6-32 x 7/8"
1. Arrange the button caps
and/or spacers in position
according to the program
plan. Attach the plastic
button support to the
button caps/spacers, and
put the assembled parts in
place on the rear housing
and switch assembly.
2. Carefully position the
bezel assembly, LED edge
first, down and over the
button caps/spacers and
rotate slightly into
position on the rear
housing and switch assembly.
Crestron C2N/C2NI-CB Series
DESCRIPTION
Rear housing with switch circuitry attached
Bezel and metal plate assembly, with ground wire
Used to connect Cresnet network cable to the keypad
Used to attach the bezel assembly to the keypad rear
housing and switch assembly
Switch cover for a single row switch
Switch cover for two switches that function as one
Switch cover for three switches that function as one
Switch cover for single non-operational switch
Switch cover for two non-operational switches
Switch cover for three non-operational switches
Used to hold the button caps/spacers together in
position
Used to attach the assembled keypad to a back box
Rear Housing
and Switch
Ass'y
Button Caps
and Spacers
Operations & Installation Guide - DOC. 6346A
Plastic
Button
Support
Advertisement
Table of Contents
