SAB Heli Division Goblin 700 Manual page 8

Box 1, Bag for page 7
SERVO ASSEMBLY
The linkage ball must be positioned 18 mm out on the servo arm. The recommended servo arm to
use is: SAB p/n [HA050/HA051].
Ensure the alignment of the servo arms (and sub trim is set) before installation of the servos in the
model.
Proceed with installation following the instructions below. You can use the G10 servo tool to align
the front servo arms with the theoretical horizontal line. (Figure 3)
Socket screw M3x6mm
(HC044-S)
Uniball M2
(H0064-S)
Servo Arm
(HA050-S)
Socket screw M2x6mm
(HC004-S)
Standard Servo
Front Servo
Page 7
SWASHPLATE SERVOS ASSEMBLY
18mm
Servo Tool
Rear Servo
Socket Head Cap
Screw M2.5x8mm
(HC020-S)
Servo Spacer
(H0075-S)
Socket Head Cap
Screw M2.5x8mm
(HC020-S)
Socket Head Cap
Screw M2.5x8mm
(HC020-S)
Servo Spacer
(H0075-S)