Tool Kit Assembly - SAB Heli Division Goblin 700 Manual

TAIL BOOM ASSEMBLY
TAIL BOOM ASSEMBLY
To fit the tail belt, loosen the tail boom by loosening the 2 M3 screws (Fig.1).
*Install the belt onto the tail front pulley, checking the direction of rotation.
*Rotate the tail drive several times by hand.
*Tension the tail belt by using the tool kit to slide the boom backwards. Then slowly tighten the two red screws.
How to use the tail belt tension tool:
1. Push the plastic pad into its seat by unscrewing the orange M4x10 screw.
2. Install the tool on the boom, it needs to touch the H1371 clamp.
The yellow M3 set screw can be used to make sure the tool is parallel to the boom clamp.
3. Tighten the pink M4x10 screw to lock the tool onto the boom.
4. Turn the orange M4x10 screw to tension the tail belt.
This will push the boom back, thus tightening the tail belt.
5. Once the correct tension is achieved, tighten the two boom clamps with the two M3 screws.
6. Remove the tool before flight.
NOTE: Correct Tensioner
Parallel to the Frame
NOTE: Correct Tightening
Aprrox 0-0.5mm
Screw M3x18
[HC079-S]
[H1402-03]
[H1402-01]
Socket Head Cap
Screw M4x10mm
(HC102-S)
Box 2, Bag for page 30

TOOL KIT ASSEMBLY

Oring
Tighten the Screw
for tension the belt
Set Screw M3x20
[HC150-S]
Nut M3
[HC206-S]
[H1402-02]
Screw M4x10
[HC102-S]
Page 30