SAB Heli Division Goblin 700 Manual page 23

ENGINE UNIT ASSEMBLY
INSTALLATION OF THE RPM SENSOR
On the RAW nitro it is possible to use two different methods to install an RPM sensor.
The first is a backplate sensor as demonstrated in the picture on the right.
P.S: Not all YS engines can support this method. Please seek further guidance from your engine
manufacturer.
The second is to use two magnets on the fan. Please use the following methods for installation:
Install 2 magnets on the fan with epoxy glue
(please ensure to clean the parts with degreaser before glueing together)
[ Fig. 1 ] ). To install the sensor, you can use the two pre-cut M2.5 holes.
Not all sensors are the same, so you can adapt the position with the carbon support (H0729).
With Align and Spartan sensors, you can use the part of the support that already has holes in it.
With any other sensor, you can use the part without holes and adapt as required.
CUT
H0729-S RPM Sensor Support
Magnet
RPM Sensor
Support
Sensor
Socket Head Cap
Screw M2.5x6mm
(HC018-S)
Box 3, Bag for page 22
ENGINE
ASSEMBLY
Page 22