SAB Heli Division Goblin 700 Manual page 34

Box 2, Bag for page 33
FBL PLATE ASSEMBLY
NOTE: 2mm thick tape for the gyro is recommended.
CF FBL Mount
(H1237-S)
Socket Head Cap
Screws M3x6mm
(HC044-S)
If you do not want to use the dampeners, you can setup a rigid FBL mount support using the screws
and bushings supplied in bag 33-2
Page 33
Note: Tighten carefully.
Overnightening can
damage the dampeners.
Flat Head Cap
Screws M3x5mm
(HC132-S)
Note: Tighten by hand.
Overnightening can
damage the dampeners.
Rubber 65 shore
(HC573-S)
CF RX Mount
(H1399-S)
NOTE: Use this plate
if you have separate RX.
Alu FBL Support
(H1237-S)
INSTALLATION BATTERY/FBL/RX
GENERAL FBL POSITION
Flat Head Cap
Screws M2.5x8mm
(HC125-S)
Note: Tighten carefully.
Overnightening can
damage the screws.
Note: Tighten carefully.
Overnightening can
damage the screws.
Flat Head Cap
Screws M2.5x8mm
(HC125-S)
POSITION FOR FBL WITH
VERTICAL CABLE OUTPUT
FBL PLATE
ASSEMBLY