Table of Contents
Advertisement
TRANMISSION MODULE
The transmission module is supplied assembled and verified, ready to be used.
Explode and Spare Parts
NOTE:
Before to open the transmission
module, use heat to neutralize the
loctite. (example use a gas torch)
Main Top
Structure
(H1331-S)
Ball Bearing 2Rs
10x
24x7mm
(HC587-S)
Ball Bearing
(HC587-S)
Page 39
Main Shaft
(H1330-S)
HC230
Bushing
(H1334-S)
HC232
Ball Bearing
10x
22x6mm
(HC587-S)
[HC128]
6x
13x5mm
TRANSMISSION MODULE
MAIN SHAFT REPLACEMENT
For replacing the main shaft:
Use SAB HA076
Grease inside the module.
Shim
(HC587-S)
K Gear Z14 0.75
(H1333-S)
K Gear Z58 0.75
(H1208-S)
M4x30
(HC587-S)
Bushing
(HC587-S)
Ball Bearing 2Rs
12x
24x6mm
(HC587-S)
Pin 3x6
Main Structure
(H1332-S)
*Remove the serial number plate
*Remove the M4 screw
*Remove and replace the main shaft
*Screw in the M4 screw, with high force and using green loctite
NOTE:
Before removing the M4 screw,
use heat to break down the loctite.
(example use a gas torch).
1
2
Advertisement
Table of Contents
