Setup; Flowchart Of Starting Debugging - Renesas R0E00030AKCT00 User Manual

E30A Emulator User's Manual

2. Setup

2.1 Flowchart of Starting Debugging

The procedure for starting the debugging is shown in Figure 2.1. For details, refer to each section hereafter.
Check the package components.
↓
Install the emulator debugger.
↓
Change the settings of the hardware.
↓
Connect the AC adapter to the E30A
emulator.
↓
Connect the host machine to the E30A
emulator.
↓
Connect the E30A emulator to the user
system.
↓
Turn on the emulator.
↓
Install the USB device driver.
↓
Check the LED display of the emulator.
↓
Download the firmware.
↓
Start up the emulator debugger and set the
Init dialog.
↓
Reset the user system.
↓
Enter the ID code.
↓
Set the operating environment of the
emulator debugger.
↓
Start debugging.
Figure 2.1 Flowchart of starting the debug
R20UT0422EJ0501 Rev.5.01
Mar 15, 2016
Refer to "1.1 Package Components.
First time only
First time only Install the emulator debugger to the host machine.
Change the settings of the E30A emulator when
First time only
necessary.
First time only Connect the AC adapter to the E30A emulator.
Connect the host machine to the E30A emulator with the
First time only
USB interface cable.
Connect the E30A emulator to the user system with the
First time only
50Ω coaxial cable (gray).
Turn on the E30A emulator and user system.
The USB device driver will be installed automatically.
First time only
Check that the SYS POWER LED and SAFE LED of the
system status LEDs are lighting.
The firmware will be automatically installed as needed.
First time only
Start up the emulator debugger and set the Init dialog.
After a message dialog is displayed, reset the user
system.
If the target MCU has had its ID code set, enter the ID
code.
Set the Emem dialog.
For details, refer to the emulator debugger's online help.
2. Setup
Page 19 of 65