E30A Emulator User's Manual
3.4 Entering ID Code
If the target MCU has ID code set in it, the ID Code verification dialog box shown below is displayed. Enter the 7-byte ID
code written to the internal flash ROM into the dialog box successively. Table 3.2 shows the ID code storage area.
- Enter ID1 -- ID7 successively in that order and then click "OK". Unless all IDs match, the emulator debugger will not start.
Table 3.2 ID Code Storage Area
Address
FFFF_FFE8h
FFFF_FFE9h
FFFF_FFEAh
FFFF_FFEBh
FFFF_FFECh
FFFF_FFEDh
FFFF_FFEEh
R20UT0422EJ0501 Rev.5.01
Mar 15, 2016
Description
First byte of ID code
Second byte of ID code
Third byte of ID code
Fourth byte of ID code
Fifth byte of ID code
Sixth byte of ID code
Seventh byte of ID code
3. Starting Up the Emulator Debugger
Page 39 of 65