Yealink MeetingEye 600 Administrator's Manual page 98

Procedure
1. Do one of the following:
• On your web user interface, go to Account > H.323.
On your VCS, go to More > Settings > Advanced > Account > H.323.
•
For VP59, tap > Settings > Advanced > Account > H.323.
•
On your CTP20/CTP18, tap
2. Configure and save the following settings:
Parameter
H.323 Protocol
H.323 Account
H.323 Name
H.323 Extension
> Settings > Advanced > Account > H.323.
Description
Enable or disable the H.323
protocol.
Note: the default value is On.
Only when it is set to On can the
H.323 account be registered.
When it is set to On on both
sites, the devices can call each
other by dialing an IP address
directly.
Enable or disable the H.323
account.
Note: the default value is On. If it
is set to Off, the devices cannot
place or receive calls via the
H.323 protocol.
Configure the device name
that can be identified by the
gatekeepers and gateways.
Note: the default value is blank.
If two devices are registered
to the same gatekeeper, they
can make point-to-point calls by
dialing their H.323 names.
Configure the device extension
that can be identified by the
gatekeepers and gateways.
Note: the default value is blank.
If two devices are registered
to the same gatekeeper, they
can make point-to-point calls by
dialing their extensions.
| Configuring Account Settings | 98
Configuration Method
Web user interface
Endpoint
CTP20/CTP18
Web user interface
Endpoint
CTP20/CTP18
Web user interface
Endpoint
CTP20/CTP18
Web user interface
Endpoint
CTP20/CTP18