Yealink MeetingEye 600 Administrator's Manual page 72

Procedure
1. Do one of the following:
• On your web user interface, go to Network > LAN Configuration > IPv6 Config.
On your VCS: go to More > Settings > Network Setting > Wired Network > IPv6.
•
For VP59, tap > Settings > Network Setting > Wired Network > IPv6.
•
On your CTP20/CTP18, tap
Network > IPv6.
2. Configure and save the following settings:
Parameter
DHCP
Static IP
IP Address
IPv6 prefix((0~128)/
IP prefix
> Settings > Network Setting > Host Network > Network > Wired
Description
Enable or disable the system to
obtain network settings from the
DHCP server.
Note: the default value is On.
If you change this parameter, the
system will reboot to make the
change take effect.
Enable or disable the system
to manually configured IPv6
network settings.
Default: Off.
If you change this parameter, the
system will reboot to make the
change take effect.
Configure the IPv6 address
assigned to the system.
Note: It is configurable only
when the network type is
selected as Static IP.
If you change this parameter, the
system will reboot to make the
change take effect.
Configure the IPv6 prefix.
Note: It is configurable only
when the network type is
selected as Static IP.
If you change this parameter, the
system will reboot to make the
change take effect.
| Configuring Network Settings | 72
Configuration Method
Web user interface
Endpoint
CTP20/CTP18
Web user interface
Web user interface
Endpoint
CTP20/CTP18
Web user interface
Endpoint
CTP20/CTP18