Yealink MeetingEye 600 Administrator's Manual page 197

Parameter
Sharpness
Brightness
Contrast
Noise Reduction (2D)
Noise Reduction (3D)
Description
Configure the sharpness of the
camera's image.
The sharpness is an indicator
that reflects the definition of the
image plane and the sharpness
of image edge. Increasing the
sharpness will improve the
definition of the image. However,
if the sharpness is set too high,
the image will look distorted and
glaring.
Note: the value is from 0 to 100.
The default value is 15.
Configure the brightness of the
camera's image.
Note: the value is from 0 to 100.
The default value is 50.
Configure the contrast of the
camera's image.
Note: the value is from 0 to
100. For VC880/VC800/VC500/
VC200/PVT980/PVT950,
the default value is 49; for
MeetingEye 600/ MeetingEye
400/PVT960/PVT940/VC200-E,
the default value is 50.
Specify the noise reduction (2D)
mode.
The available modes are
described as below:
• Off
• Low
• Middle
• High
Default: Middle.
Specify the noise reduction (3D)
mode. It indicates the coefficient
of the reduced noise in the
image. The higher the coefficient
is, the smaller the noise is.
Valid value: 0 - 22. The default
value is 3.
| Configuring Camera Settings | 197
Configuration Method
Web user interface
Endpoint
CTP20/CTP18
Web user interface
Endpoint
CTP20/CTP18
Web user interface
Endpoint
CTP20/CTP18
Web user interface
Endpoint
CTP20/CTP18
Web user interface
Endpoint
CTP20/CTP18