Yealink MeetingEye 600 Administrator's Manual page 95

Parameter
Outbound Proxy Server/
Outbound Server
Outbound Port/Port
Transport
Server Expires
Note: If you want to use SIP Account to make private-to-public calls, you also need to enable
the static NAT settings or STUN feature for the SIP protocol.
Related tasks
Configuring STUN
Description
Configure the IP address or
domain name of the outbound
proxy server for this SIP
account.
Note: only the outbound proxy
server is enabled do you need to
configure this parameter.
Configure the port of the
outbound proxy server.
Note: the default port number
is 5060. The value can be any
integer from 0 to 65535.
Specify the transport protocol for
transmitting the SIP signaling.
The supported protocols are as
follows:
• UDP—it provides the
best transmission for SIP
signaling.
• TCP—it provides a reliable
transmission for SIP
signaling.
TLS—it provides a safe
•
transmission for SIP
signaling. TLS is available
only when the device is
registered on a SIP server
that supports TLS.
• DNS-NAPTR—the device
performs the DNS NAPTR
and SRV request to find the
service type and the port if no
server port is given.
Default: UDP.
The registration timeout (in
seconds) of the device.
After the timeout, the device will
send the registration request to
the SIP server again.
Default: 3600 seconds.
| Configuring Account Settings | 95
Configuration Method
Web user interface
Endpoint
CTP20/CTP18
Web user interface
Endpoint
CTP20/CTP18
Web user interface
Endpoint
CTP20/CTP18
Web user interface
Endpoint
CTP20/CTP18