Progress PCD46102X User Manual page 43

Problem
The display shows "C2".
The display shows an error
code that is not in this table.
The descaling procedure is
interrupted before it finishes.
The descaling procedure is
interrupted before it finishes.
There is no water inside the
grill- / roasting pan after the
descaling procedure.
There is dirty water on the
bottom of the cavity after the
descaling cycle.
The cleaning function is in‐
terrupted before it finishes.
The cleaning function is in‐
terrupted before it finishes.
There is too much water on
the bottom of the cavity after
the end of the cleaning func‐
tion.
There is no good perform‐
ance of the cleaning proce‐
dure.
There is no good perform‐
ance of the cleaning proce‐
dure.
Possible cause
You want to start the Defrost
function, but you did not re‐
move the core temperature
sensor plug from the socket.
There is an electrical fault.
There was a power cut.
The function was stopped by
the user.
You did not fill the water
drawer to the maximum lev‐
el.
The grill- / roasting pan is on
a wrong shelf position.
There was a power cut.
The function was stopped by
the user.
You sprayed too much de‐
tergent in the appliance be‐
fore the activation of the
cleaning cycle.
The initial oven cavity tem‐
perature of the steam clean‐
ing function was too high.
You did not remove the side
grids before the start of the
cleaning procedure. They
can transfer heat to the
walls and decrease the per‐
formance.
Progress 43
Remedy
Remove the core tempera‐
ture sensor plug from the
socket.
• Deactivate the oven with
the house fuse or the
safety switch in the fuse
box and activate it again.
• If the display shows the
error code again, contact
the Customer Care De‐
partment.
Repeat the procedure.
Repeat the procedure.
Check if the a descaling
agent / water is present in
the water drawer body.
Repeat the procedure.
Remove the residual water
and the descaling agent
from the bottom of the oven.
Put the grill- / roasting pan
on the first shelf position.
Repeat the procedure.
Repeat the procedure.
Cover all parts of the cavity
with a thin layer of the deter‐
gent. Spray the detergent
evenly.
Repeat the cycle. Run the
cycle when the appliance is
cold.
Remove the side grids from
the appliance and repeat the
function.