Table of Contents
Advertisement
clean the steam generation circuit from
residual stone.
Select the function from the menu:
The duration of the complete procedure is
about 2 hours.
The light in this function is off.
1. Remove all accessories.
2. Make sure that the water drawer is
empty. Activate Tank Emptying - S1
function if needed.
3. Put the tray on the first shelf position.
4. Put 250 ml of the descaling agent in
the water drawer.
5. Fill the remaining part of the water
drawer with water to the maximum
level until the acoustic signal sounds
or the display shows the message.
The duration of the procedure is about
1 hour 40 minutes.
6. Activate Descaling function - S3. Refer
to "Activating a cleaning function".
7. After the end of the first part, empty
the tray and put it on the first shelf
position again.
8. Activate the Rinsing function. Refer to
"Steam generation system - Rinsing -
S4".
Remove the tray after the end of the
procedure.
If the function Descaling is not
performed in the correct way,
the display will show a
message to repeat it.
If the appliance is humid and wet, wipe it
out with a dry cloth. Let the appliance dry
fully with the door open.
Descaling reminder
There are two descaling reminders which
remind you to perform the function:
Descaling. These reminders activate each
time you switch off the appliance. When
reminder is active S3 flashes in the
display.
• The soft reminder reminds and
recommends you to perform the
descaling cycle.
• The hard reminder obligates you to
perform the descaling. If you do not
descale the appliance when the hard
.
reminder is on, you cannot use the
steam functions. You cannot disable
the descaling reminder.
Steam generation system -
Rinsing - S4
Remove all accessories.
The duration of the function is around 30
minutes.
The light in this function is off.
1. Put the tray on the first shelf position.
2. Fill the water drawer with fresh water
to the maximum level until the acoustic
signal sounds or the display shows the
message.
3. Activate Rinsing function - S4. Refer to
"Activating a cleaning function".
Remove the tray after the end of the
procedure.
Replacing the lamp
WARNING! Risk of electric
shock.
The lamp can be hot.
1. Turn off the oven.
Wait until the oven is cooled down.
2. Disconnect the oven from the mains.
3. Put a cloth on the bottom of the cavity.
The top lamp
1. Turn the lamp glass cover to remove it.
2. Remove the metal ring and clean the
glass cover.
3. Replace the lamp with a suitable 300
°C heat-resistant lamp.
Progress 41
Advertisement
Table of Contents
