Table of Contents
Advertisement
40 Progress
Activating a cleaning function
1. Activate the appliance.
2. Touch
until the display showsS1. In
some models you can also choose S2,
S3, S4.
3. Touch
or
function.
4. Touch
to confirm.
Tank Emptying - S1
Remove all accessories.
The cleaning function removes the
residual water from the water drawer. Use
the function after the steam cooking
function.
The duration of the function is around 6
minutes.
The light in this function is off.
1. Put the tray on the first shelf position.
2. Activate Tank Emptying function - S1.
Refer to "Activating a cleaning
function".
3. Touch
.
Remove the baking tray after the end of
the procedure.
Steam Cleaning - S2
Remove as much dirt as possible
manually.
Remove the accessories and the shelf
support to clean the side walls.
The steam cleaning functions support the
steam cavity cleaning of the appliance.
For a better performance you
should start the cleaning
function when the appliance is
cool.
The specified time is related to
the duration of the function and
does not include the time
required for cleaning of the
cavity by the user.
to select a cleaning
When the steam cleaning function is
active, the lamp is off.
1. Fill the water drawer to the maximum
level (around 950 ml of water) until the
acoustic signal sounds or the display
shows the message.
2. Activate Steam Cleaning function - S2.
Refer to "Activating a cleaning
function".
The duration of the function is around
30 minutes.
An acoustic signal sounds when the
programme is completed.
3. Touch a sensor field to deactivate the
signal.
4. Wipe the internal surface of the
appliance with a non-abrasive surface
care sponge. You can use warm water
to clean the cavity.
After cleaning keep the appliance door
open for approximately 1 hour. Wait until
the appliance is dry. Let the appliance dry
fully with the door open. To speed up the
drying you can close the door and heat up
the appliance with True Fan Cooking at
temperature 150°C for approximately 15
minutes. You can get maximum effects of
the cleaning function if you manually clean
the appliance immediately after the
function ends. Repeat the procedure a
second time if the level of dirt is high.
Cleaning Reminder
This function reminds you that the
cleaning is necessary and that you should
perform the function: S2.
You can enable / disable this function in
the settings menu.
Steam generation system -
Descaling - S3
When the steam generator operates, there
is an accumulation and deposition of
limestone inside because of calcium
contents in the water. This can have a
negative effect on the steam quality, on
the performance of the steam generator
and on the food quality. To prevent this,
Advertisement
Table of Contents
