Windows Xp Usb Driver - Analog Devices ADSP-21992 EZ-KIT LITE System Manual

To install the USB driver:
1. If VisualDSP++ 3.5 is already installed on your system, go to
step 2.
Otherwise, run VisualDSP++ 3.5 installation. Refer to the Installa-
tion Quick Reference Card for VisualDSP++ for a detailed
installation description.
When installing VisualDSP++ 3.5 on Windows 2000, make sure
the appropriate EZ-KIT Lite component is selected for the
installation.
2. Connect the EZ-KIT Lite device to your PC's USB port.
Windows 2000 automatically detects an EZ-KIT device and auto-
matically installs the appropriate driver for the selected device (see
step 1).
3. Verify the installation by following the instructions in
Driver Installation" on page

Windows XP USB Driver

VisualDSP++ 3.5 installation software pre-installs the necessary drivers for
the selected EZ-KIT Lite. The install also upgrades an older driver if an
older driver be detected in the system.
$
Prior to running the VisualDSP++ 3.5 installer, ensure that no
other Hardware Wizard windows are running in the background.
If a wizard window is running, close it before starting the installer.
To install the USB driver:
1. If VisualDSP++ 3.5 is already installed on your system, go to
Step 2.
Otherwise, run VisualDSP++ 3.5 installation. Refer to the Installa
tion Quick Reference Card for VisualDSP++ for a detailed installa-
ADSP-21992 EZ-KIT Lite Evaluation System Manual
1-15.
Getting Started
"Verifying
1-13