Windows Xp Usb Driver - Analog Devices ADSP-21262 EZ-KIT Lite Manual

Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com.
Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from
To install the USB driver:
1. If VisualDSP++ 3.5 is already installed on your system, go to
step 2. Otherwise, run VisualDSP++ 3.5 installation. Refer to the
VisualDSP++ 3.5 Installation Quick Reference Card for a detailed
installation description. When installing VisualDSP++ 3.5 on
Windows 2000, make sure the appropriate EZ-KIT Lite compo-
nent is selected for the installation.
2. Connect the EZ-KIT Lite device to your PC's USB port.
Windows 2000 automatically detects an EZ-KIT device and auto-
matically installs the appropriate driver for the selected device (see
step 1).
3. Verify the installation by following the instructions in
Driver Installation" on page

Windows XP USB Driver

VisualDSP++ 3.5 installation software pre-installs the necessary drivers for
the selected EZ-KIT Lite. The install also upgrades an older driver if such
is detected in the system.
Prior to running the VisualDSP++ 3.5 installer, ensure there are no
other Hardware Wizard windows running in the background. If
there are any wizard windows running, close them before starting
the installer.
To install the USB driver:
1. If VisualDSP++ 3.5 is already installed on your system, go to
step 2. Otherwise, run VisualDSP++ 3.5 installation. Refer to the
VisualDSP++ 3.5 Installation Quick Reference Card for a detailed
ADSP-21262 EZ-KIT Lite Evaluation System Manual
Getting Started
1-15.
"Verifying
1-13