Programmable Flag Pins Interface; Pwm Generation Unit Interface; Auxiliary Pwm Unit Interface; General-Purpose Timer Signals - Analog Devices ADSP-21992 EZ-KIT LITE System Manual

Programmable Flag Pins Interface

The SPORT pins are available at the SPORT interface connector (
Refer to Table 3-8 on page 3-22

PWM Generation Unit Interface

All six output signals,
PWM
( ). The
P10 PWMSYNC
input can be applied at connector
in section 4.4 for the configuration of
Three jumpers are provided for the configuration of the
Unit of the ADSP-21992.
is used to enable/disable
JP6
the polarity of the

Auxiliary PWM Unit Interface

Both outputs signals (
AUXPWM
. An
P10 PWMTRIP
provided to enable/disable the
on page 3-24 for the configuration of

General-Purpose Timer Signals

The three general-purpose timer input/output signals (
) are available at connector
TMR2
the configuration of
ADSP-21992 EZ-KIT Lite Evaluation System Manual
for the configuration of
, are available at the
AH-CL
output is also available at connector
P10
is used to enable/disable the
JP5
switched reluctance mode.
PWM
output signals.
PWM
and
AUX0
input can be applied at connector
PWMTRIP
P10
.
P10
EZ-KIT Lite Hardware Reference
PWM
. Refer to Table 3-10 on page 3-24
.
P10
) are available on connector
AUX1
P10
input signal. Refer to
.
P10
. Refer to Table 3-10 on page 3-24
).
P2
.
P2
output connector
. A
P10 PWMTRIP
Generation
PWM
input.
PWMTRIP
configures
JP7
. A jumper ( ) is
JP8
Table 3-10
, 1, and
TMR0 TMR
for
3-9