Analog Devices ADSP-21992 EZ-KIT LITE System Manual page 26

Installation Tasks
To connect the EZ-KIT Lite board:
1. Remove the EZ-KIT Lite board from the package. Be careful when
handling the board to avoid the discharge of static electricity,
which may damage some components.
2. Confirm that your board is set up in the default configuration
before going to step 3. Refer to
3. Connect your power supply to
ADSP-21992 EZ-KIT Lite board contains a 5-way terminal block
for connection of external power supplies. For correct operation,
the following supplies are required:
• +5V, 800 mA (VDD)
• +5V, 60 mA (+AVDD)
• -5V, 60 mA (-AVDD)
• Digital Ground (DGND)
• Analog Ground (AGND)
Regulators on the board provide the required +3.3V, +2.5V, and
±2.5V.
4. Connect one end of the USB cable to an available full-speed USB
port on your PC and connect the other end to
ADSP-21992 EZ-KIT Lite board.
1-6 ADSP-21992 EZ-KIT Lite Evaluation System Manual
Figure 3-3 on page 3-11
on the EZ-KIT Lite board. The
P1
P11
on the