Table of Contents
Advertisement
4.1.4
Split mode
Split value
4.1
PROFIBUS
3
4.1.1
Bus Address
4.1.2
Ident-Nr.
4.2
Digit.Output
4.2.1
Function
4.2.2
Signal Type
4.2.3
Pulse Rate
Engr. Unit
Pulse Rate
4.2.4
Pulse Width
TRANSMAG 2 with MAG 911/E
Operating Instructions, 03/2021, A5E00102775-AC
The split mode divides the measuring range
into two domains:
•
Domain 1 from 0 to
'Split value'
•
Domain 2 from 'Split
value' to 'URV'
(upper range value, menu3.1.2)
At digital outputs 1 or 2, it is possible to
indicate whether the current measured val‐
ue is within domain 1.
To do this, the function 'Split value active'
must be set (menu 4.2.1 and 4.3.1)
End value of domain 1 (only when 'Split
mode = active')
PROFIBUS communication
PROFIBUS address
Selection of appropriate device database
file (GSD)
1
Frequency or pulse signal for flow or alarm
signal
Assignment of a function to digital output 1
'Split value active': the active output indi‐
cates a current flow value in the 0 to 'Split
value' range (not effective for PROFIBUS).
Definition of signal logic for active event
Number of pulses per unit of quantity (only
effective with "Pulse" function)
Engineering unit of quantity to which the
number of pulses refers
Number of pulses per unit of quantity
(only with "Pulse" function)
Inactive
•
Inactive
•
Active
URV (menu
Depends on the nominal
3.1.2)
width (corresponding to
0.25 ... 12 m/s, <URV)
126
1 to 126
Manufact.spec.
•
Profile spec.
•
Manufact.spec.
Pulse
•
Pulse, Frequency,
•
Alarm, Flow direction
forw.
•
Flow min, Flow max,
Flow min/max,
•
Total. forw. max,
•
Total. rev. min,
•
Total. net max,
•
Total. net min
•
Split value active,
•
No function
Passive-pos.
•
Active-pos., 1, 2
•
Active-neg., 1, 2
•
Passive-pos.
•
Passive-neg.
DN1...12: Imp/l
•
pulses/l, m
MGal, ImpGal, Mimp•
>DN12: Imp/m
3
Gal, kg, t, lb,
•
0.01 ... 9999 pulses/unit
Depending on
the nominal
width 10Imp/l...
1Imp/m
3
+0.1 ms
0.1 ... 2000 ms
Parameters
, Ml, ft
, Gal,
3
3
99
Advertisement
Table of Contents
