Parameters
4.2.5
Fullsc. Freq
4.3
Digit.Output2
4.3.1
Function
4.3.2
Signal type
4.3
Digit.input
4.3.1
Function
4.3.2
Signal Type
Parameters apply only to devices with 20 mA/Hart communication and digital output 2 (7ME5034-0xxxx)
1)
2)
Parameters apply only to devices with 20 mA/Hart communication and digital input (7ME5034-2xxxx)
3) Parameters apply only to devices with PROFIBUS communication (7ME5034-1xxxx)
Identification
Table A-5
Function group Identification parameters
5.1
Funct. Unit
5.1.1
Tag
5.1.2
Descriptor
5.1.3
Message
5.2
Manuf.Ident.
100
Frequency output at full scale flow value at
digital output 1 (only effective for "Frequen‐
cy" function)
1
Assignment of a function to digital output 2
'Split value active': the active output indi‐
cates a current flow value in the 0 to 'Split
value' range (not effective for PROFIBUS).
Definition of signal logic for active event
2
Assignment of a function to the input:
Measured value=0:
Measured value is set to 0 (affects all out‐
puts and totalizers)
Totalizer reset: reset+start
Definition of signal logic
Tag number
Tag descriptor
Tag message
10000 Hz
2 ... 10000 Hz
Alarm
•
Alarm, Flow dir. forw.,
•
Flow min, Flow max,
Flow min/max,
•
Total. forw. max,
•
Total. rev. max,
•
Total. net max,
•
Total. net min,
•
Split value active,
•
No function
Contact closes
•
Contact closes
•
Contact opens
Measured value
•
Meas. val. = 0,
= 0
•
Total. forw. reset,
•
Total. rev. reset,
•
Total. net reset,
•
Total. all reset,
•
No function
High-active
•
High-active,
•
Low-active
(Customer-spe‐
Text max.:
cific)
•
32 characters 3 /
•
8 characters 1,2
(Customer-spe‐
Text max.
cific)
•
32 characters 3
DN 2...12: l
•
16 characters 1,2
DN >12: m
3
(Customer-spe‐
Text max. 32 characters
cific)
TRANSMAG 2 with MAG 911/E
Operating Instructions, 03/2021, A5E00102775-AC