Extron electronics SF 28PT User Manual page 29

2"
E
T
F
10"
PendantConnect-2
Cable
Figure 23. Cutting Bulk Cable for Ceiling Bracket
ATTENTION: Do not use regular wire cutters to cut through the steel cable.
Ordinary wire cutters may be damaged when attempting to cut through the
steel cable. You must use a suitable cable cutter to cut the steel cable.
N'utilisez pas de cisaille standard pour couper le câble en
ATTENTION :
acier. Ce type de cisaille peut être endommagé lors de la coupe du câble en
acier. Vous devez utiliser une pince coupe-câble adaptée à ce type de câble.
5. Determine and mark the strip points, E and F, as shown in the above illustration where
E is 2 inches from the cut end and F is 10 inches from the cut end.
6. Strip off the cable jacket from the cable at the strip points, E and F.
7. On the speaker end of the cable, form a loop with the steel cable using the cable lock.
Make sure that a least 1 inch of steel cable protrudes from the cable lock and that the
end of the cable lock is at least 2 inches from the the top of the speaker hook. Position
the two loops through the hook.
8. Route the free end of the PendantConnect-2 cable through the ceiling bracket cover
with the magnetic side of the cover facing the ceiling bracket (see the illustration below).
9. Route the free ends of the two steel support cables through the two ceiling bracket
cable locks (see figure 23)
is flush with the top of the grommet as shown in the illustration below (see the inset side
view ) . Inserting the steel cable through the bottom of the cable lock locks the cable
2
in place. Pressing the cable lock release unlocks the cable.
F
≥2"
≥1"
≥2"
B
Floor
. Pull the steel support cable up until the top of the jacket
4
SF 28PT User Guide • Reference Information
A
Strip Point E = 2"
Strip Point F = 10"
Total Length T = A - B - 5.26"
T= Total length of PendantConnect-2 cable
1
21