Table of Contents
Advertisement
Connecting to the EXTender 1000
This page provides the necessary information to configure the PBXgateway II with the EXTender 1000 for
connection over a standard telephone (PSTN) network.
Note: The EXTender 1000 is supported by the DEFINITY protocol only.
Prerequisites for Configuration
•
The 2
I channel (CH2) of each PBX port assigned to a remote user must be configured. See page
nd
32.
•
The PBXgateway II (at the corporate site) and the EXTender 1000 (at the teleworker site) must be
installed properly and the network link between both devices must be operational.
•
The network administrator must assign telephone numbers (Dial numbers) to both the PBXgateway II
and EXTender 1000 units.
•
The network administrator must provide the remote users with User ID's and Connect Passwords (if
assigned) or port numbers if not using User ID's.
For detailed instructions on connecting the EXTender 1000 to the PBXgateway II, see the MCK Analog
EXTender 1000u Owner's Manual.
Configuration Items
The following parameters need to be configured on the PBXgateway II. Refer to the PBXgateway II
System Administrator's Guide for complete set up information.
You must...
Set the Phone Port voice
compression Method
parameter to G729A.
Set the CH2 Mode parameter
to Data-Static or Data-Hunt
Set the CH2 Data Mode
parameter to Modem
Check the User List User List-
>List Users
PBXgateway II Quick Installation Guide
To.....
Provide adequate bandwidth.
Enable a complete network connection
between the EXTender 1000 and the
PBX
Identifies the EXTender 1000 as the
remote module connecting to the PBX.
Make sure a valid password exists for
each EXTender 1000 user.
Default Settings
ADPCM 32 (on all
phone ports)
Voice
ISDN-56K
--
50
Advertisement
Table of Contents
