Table of Contents
Advertisement
Figure 10:
Power-up LEDs
On initial power-up (or before the config file has been changed) the Management Interface (MI) will ask
you to run the "Setup Wizard".
If you type "Yes" the wizard will ask a series of configuration questions (see next page).
If you type "No" the PC displays the following message:
Press "Enter" to start the PBXgateway II shell.....
Note: If the PBXgateway II is powered up prior to opening the terminal program, this message will not
appear.
Go to "Basic Configuration" on page 23.
PBXgateway II Quick Installation Guide
21
Advertisement
Table of Contents
