Table of Contents
Advertisement
Connecting to the EXTender 3000
This page provides the necessary information to configure the PBXgateway II with the EXTender 3000 for
connection over an ISDN network.
Prerequisites for Configuration
•
The 2
I channel (CH2) of each PBX port assigned to a remote user must be configured. See page
nd
32.
•
The PBXgateway II (at the corporate site) and the EXTender 3000 (at the teleworker site) must be
installed properly and the network link between both devices must be operational.
•
The network administrator must assign telephone numbers (Dial numbers) to both the PBXgateway II
and EXTender 3000 units.
The network administrator must provide the remote users with the following ISDN information:
•
ISDN Network Switch type
•
2 Service Profile Identifier numbers (SPIDs)
•
2 Directory numbers (DNs)
•
Terminal Endpoint Identifier (TEI)
The network administrator must provide the remote users with User ID's and Connect Passwords (if
assigned) or port numbers if not using User ID's.
For detailed instructions on connecting the EXTender 3000 to the PBXgateway II, see the MCK
EXTender 3000 Remote Module User's Guide.
Configuration Items
The following parameters need to be configured on the PBXgateway II.
You must...
Set the Phone Port voice
compression Method
parameter to ADPCM32.
Set the CH2 Mode
parameter to Data-Static
or Data-Hunt
Set the CH2 Data Mode
parameter to MISDN-64K
or ISDN-56K
Check the User List User
List->List Users
PBXgateway II Quick Installation Guide
To.....
Provide adequate bandwidth.
Enable a complete network connection
between the EXTender 3000 and the
PBX
Identifies the EXTender 3000 as the
remote module connecting to the PBX.
Make sure a valid password exists for
each EXTender 3000 user.
Default Settings
ADPCM 32 (on all
phone ports)
Voice
ISDN
--
51
Advertisement
Table of Contents
