Table of Contents
Advertisement
ADCP-92-082 • Issue 2 • 10/2008
3.2
Installing a Cable Clamp for MPO Trunk Cable
Note: This procedure requires use of the MPO trunk cable clamp kit, which can be
ordered from ADC using catalog # TFP-ACC002. This kit is required for routing MPO
trunk cable in panels with MPO adapter packs. This kit may also be used for routing MPO
trunk cable in panels with MPO cassettes, but the kit is not required for MPO cassette
applications.
Note: When the MPO trunk cable clamp kit is used, there are limitations on the number of
panels that can be stacked up on the rack in certain configurations. For more information,
refer to the instructions (ADCP-92-080) provided with the kit.
For panels with MPO adapter packs, an MPO trunk cable must be installed and routed. The
procedure is the same regardless of the type of panel being installed.
The MPO trunk cable can enter the panel from the left or right side of the panel (as viewed from
the rear of the panel).
Determine the direction of cable entrance and install the cable clamp. Some orientation
examples are shown in
LEFT SIDE
VERTICAL MPO
TRUNK CABLE
ENTRANCE
Page 14
© 2008, ADC Telecommunications, Inc.
Figure
14.
SWELL
LATCH (2)
Figure 14. Cable Clamp Assembly for MPO Trunk Cable
REAR COVER CAN BE
REMOVED TO AID IN
MPO TRUNK ROUTING
RIGHT SIDE
HORIZONTAL MPO
TRUNK CABLE
ENTRANCE
22179-A
Advertisement
Table of Contents
