Rj45 Lan Ports; Usb Ports - DFI ST102-CS User Manual

RJ45 LAN Ports

LAN 2
LAN 1 LAN 2
LAN 1
Features
• LAN 1: Intel ® I211AT PCIe (10/100/1000Mbps)
®
• LAN 2: Intel I219V/LM (10/100/1000Mbps)
Activity/Link LED
LED Behavior Description
Off No link
Blinking Data Activity
On Link
The two LAN ports allow the system board to connect to a local area network with a network hub.
BIOS Setting
Configure the onboard LAN ports in the Advanced menu ("ACPI Configuration" submenu) of the
BIOS. Refer to Chapter 7 - BIOS for more information.
Driver Installation
Install the LAN drivers. Refer to Chapter 8 - Supported Software for more information.
ST102-CS
Speed LED
LED Behavior Description
Off 10Mbps connection
Green 100Mbps connection
Orange 1Gbps connection

USB Ports

USB 3.1 Gen 1
USB 4
USB 2
USB 3
USB 1
▲ CS101-H310
USB 3.1 Gen 2
USB 2 USB 4
USB 1 USB 3
▲ CS101-Q370/C246
The USB device allows data exchange between your computer and a wide range of simultane-
ously accessible external Plug and Play peripherals.
The motherboard is equipped with 4 onboard USB Type A ports (USB 1-2/3-4) at the rear
panel I/O ports. The four USB rear ports support USB 3.1 Gen 1 on CS101-H310, and USB 3.1
Gen 2 on CS101-Q370/C246. Two 10-pin USB internal connectors allow you to connect to 4
additional USB 2.0 ports (USB 5-6/7-8)
The additional USB ports may be mounted on a card-edge bracket. Install the card-edge
bracket to an available slot on the system chassis and then insert the USB port cables to a
connector.
18
USB 5
USB 6
USB 2.0 USB 2.0
USB 7-8
www.dfi.com