Chapter 2 - Getting Started - DFI ST102-CS User Manual

Chapter 2 - Getting Started

Preparing the System
Before you start using the system, you need the following items:
• SATA hard drive
• AC power adapter
• Screwdriver
• Memory modules
Installing Devices
The following devices can be installed in the system.
• Memory module(s)
• SATA hard drive(s)
Configuring the BIOS
To get you started, you may need to change configurations such as the date, time and the
type of hard disk drive.
1. Power on the system.
2. After the memory test, the message "Press DEL to run setup" will appear on the screen.
Press the Delete key to enter the BIOS setup utility.
Installing the Operating System
Depending on the method you choose to install your system, you may use a USB flash drive
or install a CD-ROM drive to run the Operating System CD.
Make sure that a SATA drive is already installed.
1. Refer to the following chapters for information on installing a SATA drive
2. Refer to your operating system manual for instructions on installing an operating system.
Installing the Drivers
The system package includes a CD disk. The CD includes drivers that must be installed to pro-
vide the best system performance. Refer to the Supported Software chapter for instructions on
installing the drivers.
ST102-CS
Chapter 2
10
www.dfi.com