Chapter 2 - Getting Started - DFI RC300-CS User Manual

Chapter 2 - Getting Started

Preparing the System
Before you start using the system, you need the following items:
• SATA hard drive
• DC Power connector
• Screwdriver
• Memory modules
Installing Devices
The following devices can be installed in the system.
• All the optional items.
• SATA HDD is not supported.
Configuring the BIOS
To get you started, you may need to change configurations such as the date, time and the
type of hard disk drive.
1. Power on the system.
2. After the memory test, the message "Press DEL to run setup" will appear on the screen.
Press the Delete key to enter the BIOS setup utility.
Installing the Operating System
Make sure that a SATA drive is already installed.
1. Refer to the following chapters for information on installing a SATA drive
2. Refer to your operating system manual for instructions on installing an operating system.
RC300-CS
Compatible MXM Modules
Type Model CUDA cores
Quadro P1000 512
Quadro P2000 768
Quadro T1000 896
Quadro RTX3000 1920
Quadro RTX5000 3072
10
Support operating
Power
temperature
47W -20°C to +70°C
58W -20°C to +70°C
50W -20°C to +70°C
80W -20°C to +55°C
-20°C to +55°C
150W (external air flow
needed)
www.dfi.com