Get Started With Your Anywhereusb; Initial Connection: Administrators Only; Next Steps After Initial Connection; Optional - Digi AnywhereUSB Plus User Manual

Get started with your AnywhereUSB

This section explains what comes with each AnywhereUSB model, how to install the necessary
software, and how to connect the hardware. After you have verified the AnywhereUSB Hub
components, the software installation, hardware connection, and initial connection process must be
done individually for each computer.

Initial connection: Administrators only

Note The steps in this process must be done by an administrator. Once the setup is complete, any
user can connect to a group, as described below in Create and configure groups.
Step 1: Verify product components
Step 2: Determine how to run AnywhereUSB Manager: Service or stand-alone
Step 3: Install the AnywhereUSB Manager
Step 4: Connect the power supply
Step 5: Connect to the device using an Ethernet LAN connection
Step 6: Verify initial connection
Step 7: Update the firmware on the AnywhereUSB

Next steps after initial connection

Step 8: Create and connect to groups
Step 9: Configure the Hub

Optional

Change the admin password on the Hub
22
AnywhereUSB® Plus User Guide