Digi AnywhereUSB Plus User Manual page 306

Services
To limit access to specified IPv6 addresses and networks:
n
(config)> add service iperf acl address6 end value
(config)>
Where value can be:
A single IP address or host name.
l
A network designation in CIDR notation, for example, 2001:db8::/48.
l
any: No limit to IPv6 addresses that can access the service-type.
l
Repeat this step to list additional IP addresses or networks.
To limit access to hosts connected through a specified interface on the AnywhereUSB
n
Plus device:
(config)> add service iperf acl interface end value
(config)>
Where value is an interface defined on your device.
Repeat this step to list additional interfaces.
To limit access based on firewall zones:
n
(config)> add service iperf acl zone end value
Where value is a firewall zone defined on your device, or the any keyword.
AnywhereUSB® Plus User Guide
Display a list of available interfaces:
Use ... network interface ? to display interface information:
(config)> ... network interface ?
Interfaces
Additional Configuration
-------------------------------------------
defaultip
defaultlinklocal
eth1
eth2
loopback
modem
(config)>
Display a list of available firewall zones:
Type ... firewall zone ? at the config prompt:
(config)> ... firewall zone ?
Zones: A list of groups of network interfaces that can be
referred to by packet
Configure the ping responder service
Default IP
Default Link-local IP
ETH1
ETH2
Loopback
Modem
306