Command Line Interface; Access The Command Line Interface; Log In To The Command Line Interface - Digi AnywhereUSB Plus User Manual

Command line interface

Access the command line interface

You can access the AnywhereUSB Plus command line interface using an SSH connection or a serial
connection. You can use an open-source terminal software, such as PuTTY or TeraTerm, to access the
device through one of these mechanisms.
You can also access the command line interface in the WebUI by using the Terminal, or the Digi
Remote Manager by using the Console.
To access the command line, your device must be configured to allow access, and you must log in as a
user who has been configured for the appropriate access. For further information about configuring
access to these services, see:
WebUI: Configure the web administration service
n
SSH: Configure SSH access
n

Log in to the command line interface

Command line
1. Connect to the AnywhereUSB Plus device by using a serial connection, SSH, or the Terminal in
the WebUI or the Console in the Digi Remote Manager. See
for more information.
For serial connections, the default configuration is:
n
l
l
l
l
l
For SSH connections, enter the device's default IP address.
n
2. At the login prompt, enter the username and password of a user with Admin access:
login: admin
Password: **********
The default username is admin. The default unique password for your device is printed on the
device label.
3. Depending on the device configuration, you may be presented with another menu, for
example:
Access selection menu:
a: Admin CLI
1: Serial: port1
q: Quit
Select access or quit [admin] :
Type a or admin to access the AnywhereUSB Plus command line.
AnywhereUSB® Plus User Guide
115200 baud rate
8 data bits
no parity
1 stop bit
no flow control
Access the command line interface
Access the command line interface
(9600,8,1,none,none)
672