Configure The Anywhereusb Plus Device To Use Custom Factory Default Settings - Digi AnywhereUSB Plus User Manual

Hide thumbs Also See for AnywhereUSB Plus:

Table of Contents

System administration

3. At the config prompt, enter revert:

(config)> revert

4. Set the password for the admin user prior to saving the changes:

(config)> auth user admin password pwd

5. Save the configuration and apply the change:

(config)> save

Configuration saved.

6. Type exit to exit the Admin CLI.

Depending on your device configuration, you may be presented with an Access selection

menu. Type quit to disconnect from the device.

Configure the AnywhereUSB Plus device to use custom factory

default settings

You can configure your AnywhereUSB Plus device to use custom factory default settings. This way,

when you erase the device's configuration, the device will reset to your custom configuration rather

than to the original factory defaults.

To clear the custom default configuration, press the RESET button, wait for the device to reboot,

then press the RESET button again.

Required configuration items

Custom factory default file

1. Log into the AnywhereUSB Plus WebUI as a user with Admin access.

2. Configure your AnywhereUSB Plus device to match the desired custom factory default

configuration.

For example, you may want to configure the device to use a custom APN or a particular

network configuration, so that when you reset the device to factory defaults, it will

automatically have your required network configuration.

3. On the main menu, click System. Under Configuration, click Configuration Maintenance.

AnywhereUSB® Plus User Guide

Erase device configuration and reset to factory defaults