Enable Or Disable A Packet Filtering Rule - Digi AnywhereUSB Plus User Manual

Firewall
10. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Enable or disable a packet filtering rule

To enable or disable a packet filtering rule:
É
WebUI
1. Log into the AnywhereUSB Plus WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Firewall > Packet filtering.
4. Click the appropriate packet filtering rule.
5. Click Enable to toggle the rule between enabled and disabled.
6. Click Apply to save the configuration and apply the change.
Command line
1. Log into the AnywhereUSB Plus command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
AnywhereUSB® Plus User Guide
Packet filtering
386