Ip Routing - Digi AnywhereUSB Plus User Manual

Hide thumbs Also See for AnywhereUSB Plus:

Table of Contents

IP routing

The AnywhereUSB Plus device uses IP routes to decide where to send a packet it receives for a remote

network. The process for deciding on a route to send the packet is as follows:

1. The device examines the destination IP address in the IP packet, and looks through the IP

routing table to find a match for it.

2. If it finds a route for the destination, it forwards the IP packet to the configured IP gateway or

3. If it cannot find a route for the destination, it uses a default route.

4. If there are two or more routes to a destination, the device uses the route with the longest

5. If there are two or more routes to a destination with the same mask, the device uses the route

with the lowest metric.

This section contains the following topics:

Configure a static route

Delete a static route

Policy-based routing

Configure a routing policy

Routing services

Configure routing services

AnywhereUSB® Plus User Guide

Do you have a question about the AnywhereUSB Plus and is the answer not in the manual?