Enable Configuration Mode; Enter Configuration Commands In Configuration Mode; Save Changes And Exit Configuration Mode - Digi AnywhereUSB Plus User Manual

Hide thumbs Also See for AnywhereUSB Plus:

Table of Contents

Command line interface

do not take effect until the configuration is saved.

Enable configuration mode

To enable configuration mode, at the root prompt, enter the config command without any

When the command line is in configuration mode, the prompt will change to include (config), to

indicate that you are currently in configuration mode.

There are two ways to enter configuration commands while in configuration mode:

Enter the full command string from the config prompt.

For example, to disable the ssh service by entering the full command string at the config

(config)> service ssh enable false

Execute commands by moving through the configuration schema.

For example, to disable the ssh service by moving through the configuration and then

executing the enable false command:

1. At the config prompt, enter service to move to the service node:

(config)> service

(config service)>

2. Enter ssh to move to the ssh node:

(config service)> ssh

(config service ssh)>

3. Enter enable false to disable the ssh service:

(config service ssh)> enable false

(config service ssh)>

Move within the configuration schema

configuration.

To save changes that you have made to the configuration while in configuration mode, use save. The

save command automatically validates the configuration changes; the configuration will not be saved

if it is not valid. Note that you can also validate configuration changes at any time while in

configuration mode by using the validate command.

AnywhereUSB® Plus User Guide

for more information about moving within the

Configuration mode