Digi AnywhereUSB Plus User Manual page 319

Hide thumbs Also See for AnywhereUSB Plus:
Table of Contents

Advertisement

User authentication
6. Click Apply to save the configuration and apply the change.
  Command line
1. Log into the AnywhereUSB Plus command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Enable or disable access rights for the group. For example:
Admin access:
n
To set the access level for Admin access of the admin group:
l
where value is either:
o
o
The default is full.
AnywhereUSB® Plus User Guide
(config)> auth group admin acl admin level value
(config)>
full: provides users of this group with the ability to manage the AnywhereUSB
Plus device by using the WebUI or the Admin CLI.
read-only: provides users of this group with read-only access to the WebUI and
Admin CLI.
Authentication groups
319

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the AnywhereUSB Plus and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents

Save PDF