Troubleshooting - DEPURECO TB Series Instruction And Maintenance Manual

- Switch the vacuum off by positioning the main switch to "0"
- Disconnect the vacuum cleaner from the power socket
- Unlock the HEPA filter from both sides ofthe vacuum's head
- Remove the vacuum's head
- Remove the HEPA filter and lay it on a work bench. Then unscrew the
filter fastening screw
To reassemble the filter, operate in reverse order:
- Fit the new filter and screw it onto the holding cage by means of the
screw previously removed
- Reposition the H filter on the filter chamber and lock it with the
appropriate locking hooks
- Position the vacuum cleaner's head, then lock it with the appropriate
locking hooks
- Connect the vacuum cleaner to the mains
- Switch the vacuum cleaner on by positioning the main switch to "I",
then check to make sure it works properly.
EXCLUSIVELY USE FILTERS MANUFACTURED BY DEPURECO
5.5

Troubleshooting

FAULT
DETECTED
remove the filter, put it in a plastic bag, seal it and
dispose it of according to the applicable legislation
on the type of material collected.
POSSIBLE
CAUSE
Page 32 of 38
SOLUTION
RECOMMENDED