DEPURECO TB Series Instruction And Maintenance Manual page 28

Warning!
All the operations described above must be carried out with the
plug disconnected from the socket.
Before
suitable PPE (protective clothing, goggles and/or gloves, etc.)
according to the work to be done.
Place a sign on the vacuum with the message:
"MACHINE UNDER MAINTENANCE
DO NOT START"
Before
according starting procedures.
Run a few trial operating cycles after every maintenance operation
to ensure proper machine operation.
Failure to observe these precautions can cause serious injury to
personnel.
Maintenance operations
specialised in the following sectors:
• Mechanical maintenance
• Electrical maintenance
It is the Safety Manager's duty to ensure the professionalism and skills of
these technicians.
Before starting any maintenance operation, the Safety Manager must:
- Keep unauthorised personnel out of the work area.
- Ensure that there is enough light and, if necessary, provide 24 Volt
torches.
Before starting any maintenance operation, the Maintenance technician must:
starting any maintenance
returning to use,
must be
- Ensure that the necessary tools are in good
conditions and readily available to the
maintenance technician.
- Ensure the maintenance technician is equipped
with the personal protection equipment
 Ensure that the necessary tools are in good conditions
required for the specific operation (gloves,
and readily available to the maintenance technician.
goggles, shoes, mask, etc.)
 Ensure
that the
- Make sure the maintenance technician has
with the personal protective equipment required for
carefully read the instructions contained in
the specific operation (gloves, goggles, shoes, mask,
this manual and has perfectly acquired
etc.).
knowledge on the operation of the vacuum and

Make sure the maintenance technician has read
its components.
Page 28 of 38
or cleaning
the whole system
carried out by
maintenance technician
operation, wear
must be checked
trained technicians
is equipped