IBM xSeries 240 81Y Hardware Maintenance Manual page 159

3. Attach the slide rails to the rack.
a. Insert the left slide-rail rear bracket pin into the
hole between the two cage nuts for the slide rail
at the rear of the rack. The two holes in the rear
bracket line up with the cage nuts.
b. Pull the slide-rail front bracket to the front of the
rack; insert the front bracket pin into the hole
above the cage nuts for the slide rail. The two
holes in the front bracket line up with the cage
nuts.
c. Do the same for the other slide rail.
1
Left slide rail
2
Left rear
3
Left front
d. From the outside of the rack enclosure, insert
two M6 by 16-mm screws through each slide-rail
bracket and cage nut; then, tighten the screws.
4. Attach the cable-management arm to the left rear of
the rack enclosure.
a. Align the cable-management-arm mounting
bracket with the cage nuts on the rear mounting
rail.
b. Insert two M6 by 16-mm screws to secure the
mounting bracket to the rack.
151
xSeries 240